Tub spout 4 inches above tub rim.
Bathtub faucet tub shower valve rough in height.
80 inches from the floor.
When installing a bathtub faucet or tub shower divertor valve the bathtub spout must terminate above the flood level rim of the bathtub a minimum of 2 inches this would place the stub out for.
Valve trim only 558 items.
Shower only faucets 410 items.
Tub spouts 178 items.
All shower heads 1156 items.
Bathroom sink faucets vessel faucet 54 items.
Where shower arm will go.
Hand held showers 594 items.
Tub shower faucets 407 items.
Volume control 77 items.
The mixing valve in a shower including over a tub shall be pressure balancing set at a maximum 120 f.
Faucet valves 20 to 22 inches above the floor.
Showerhead will be about 65 to 78 inches above the floor tub supply vertical.
The tub spout should be set 4 above the.
30 32 from floor to center valve body 6 from bottom end of valve body to centre of spout shower head 90 between 76 80 from floor to center depending on the height of the individual using the shower it may vary.
The water filler valve in bathtubs whirlpools shall have a temperature limiting device set at a maximum of 120 f.
The water heater thermostat cannot be used to meet these provisions.
Take into consideration whether the controls work the tub and shower since you ll want to mount them lower to accommodate tub users.
The shower head normally is located 72 to.
Shower valve and spout height is a matter of personal preference when you re building or retrofitting.
Shower and bathtub rough in details.
In a shower only unit the faucet is placed higher at 48 inches off the floor.
I usually set tub and shower faucets to 40 2 depending on the height of the family which is just about the average persons extended hand dimension.
The tub spout will generally be located 4 inches above the rim of the tub.
Standard height for the shower valve the handle that turns the shower on can be roughly waist high 36 inches above the shower floor or as high as 48 inches.
All bathroom tub shower faucets 2335 items.
Horizontally each faucet goes 4 inches to the right left of centerline.
Place the controls so that all users can easily access them.