Zone 2 same as above requires a minimum of ipx4.
Bathroom lighting zones 1 and 2.
In this zone a minimum rating of ip44 is required.
Zone 1 this area above the bath to a height of 2 25m from the floor.
The three bathroom zones are.
The lighting companies entire collection of bathroom lighting containing modern and traditional ceiling lights wall lights illuminated mirrors led energy saving lights as well as modern spot lights and bathroom chandeliers all our bathroom lighting is ip44 rated or higher making them safe for bathrooms the bathroom is divided into zones 0 1 2 and 3 and bathroom light fittings are ip.
It s also worth noting that most shower lights are rated at ip65 in any case.
Vanity light bars optimize the light in your bathroom and come in a variety of multilight styles from 1 light sconces up to 8 light bars.
If the fitting is 240v a 30ma residual current device rcd must also be used to protect the circuit in this zone.
Zone 1 is the area above the bath or shower to a height of 2 25m from the floor.
This is the area within a bath tub only 12v selv safety extra low voltage equipment can be used.
Zone 2 is an area stretching 0 6m outside the perimeter of the bath and to a height of 2 25m from the floor.
Any fitting used in this zone must be low voltage max 12v and be rated at least ip67 which is total immersion proof.
Zone 0 bathroom lights are for the inside of the bath or shower itself.
Zone 1 requires a minimum of ipx4.
0 1 2 and 3.
Zone 1 for a shower room is 2 25m from the finished floor level or the height of the fixed shower head from the finished floor level if more than 2 25m and the width of the shower basin.
In these bathroom zones an ip rating of at least ip44 is required.
The diagram shows a bathroom split into four clear zones.
If the fitting uses a 240v supply a 30ma residual current device rcd must also be used to protect the.
Zone 3 is.
Zone 1 for a bathroom is the same width as zone 0 the width of the bath extending to 2 25m above the finished floor level.
Zone 1 is for use inside a shower cubicle and around a bath and has a minimum ip rating of ip65 zone 2 is for use on the wall up to a height of 2 25m again having a minimum ip rating of ip44.
This is the area directly above a bath and within a shower cubicle.
Any fitting used in this zone must have a minimum rating of ipx4 which means it is protected against water spray from all directions.
In this zone a minimum rating of ip45 is required but it is generally accepted that ip65 is to be used.
When making your selection keep in mind that a minimal pedestal sink will probably allow a fixture with up to 3 lights while a 2 sink vanity will leave enough space for an 8 light vanity light.
Zone 1 bathroom lights can be used in the area above the bath to a height of 2.
Zone 1 is the area above the bath or shower tray to a height of 2 25m from the floor.
In addition it is good practice to consider the area around a wash basin within a 60cm radius of any tap to be considered as zone 2.
